Remote Controller Functions - Gree Neo GWH09MA-A3DNA3A Installation, Service & Troubleshooting

Remote Controller Functions

1)On/Off
Press this button to turn unit on or off
2)Mode
Press the "Mode" button to change from Auto, Cool, Dry, Fan or Heat Pump
3)Lower Temperature Setting
Each time you press the "-" button the temperature setting will lower by 10 F. Hold button down for 2 seconds to
rapidly decrease setting. The temperature range is 610 F - 860 F. In Auto Mode this button will not function.
4)Raise Temperature Setting
Each time you press the "+" button the temperature setting will raise by 10 F. Hold button down for 2 seconds to
rapidly increase setting. The temperature range is 610 F - 860 F. In Auto Mode this button will not function.
5) Fan Switch
The fan switch will adjust the fan speed between Auto, Low, Medium and High.
6) Swing Button
Press this button to stop or start the up/down swing function. Press the "+" and Swing button together
will switch between static and simple swing.
7) Clock Button
Press this button to set clock. Press "_" or "+" within 5 seconds to change time. Holding buttons down for more
than 2 seconds will speed up time. Press Clock again to save setting.
8)Timer On
Press this button to initiate the Auto-On timer. Press this button again ti disable the function. Within 5 seconds
press the + or - buttons to adjust the time value. Holding down the buttons will change time at a faster pace.
9) X-Fan
Pressing X-Fan button in Cool mode will allow indoor fan to run for 10 minutes after the cooling cycle has
stopped. This will dry off indoor coil.
10) Temp Button
This button will change the indoor display from reading indoor ambient or the indoor set temperature
11) Timer Off Button
This button performs same as Timer On button.
Product Introduction
55