Technical Data; Installing The Balance - Adam Equipment ACB-600H Manual

1.0 TECHNICAL DATA

The ACB series of precision electronic scales offers a range of capacities from 150
grams to 3 kilograms. The ACB series now includes 2 models with high
resolution,1:60,000. These are the ACB-600H and ACB-1200H.
The balances are very simple to use and are applicable for general weighing. The user
can also use the parts counting and percent weighing functions for special applications.
Special functions are available for weighing in up to 13 different units of weight.
The standard RS-232 interface allows the weight to be sent to a computer or printer.
The baud rate is adjustable from 1200 to 9600 baud.

1.1. INSTALLING THE BALANCE

♦ Unpack the balance carefully.
♦ Place the scale on a stable surface. The weighing area should be kept clean and
dry. Do not install the balance near extremes of heat and cold. Protect the balance
from vibration, dust and air draughts.
♦ Place the pan onto the pan support gently, being careful not to press on the pan.
♦ Remove the shipping protection from the side of the balance. Retain this part so that
if the balance is to be shipped again it can be inserted to protect the load cell. (See
below).
♦ Turn the adjustable feet until the balance is level (check the bubble level on the front
of the scale).
♦ Insert the power supply connector in the plug on the rear of balance. Plug the power
supply into the mains supply.
♦ Press the ON/OFF key to activate the balance.
♦ Wait until the balance AutoTest is finished and a stable zero is displayed.
© Adam Equipment Company 2000 2