Communications (Menu Options); Schedule (Menu Options); Set Clock (Menu Options); Setpoints (Menu Options) - KMC Controls BAC-19 FlexStat Series Application Manual

take effect. After restarting, most settings will
change back to their defaults.
NOTE: For customizing the display, see
Display Customization on page

Communications (Menu Options)

NOTE: On "E" models, the default protocol is
BACnet over Ethernet with a Device ID
of 1. To see new "E" models in software,
be sure the software attached to the
network can discover BACnet over
Ethernet devices. (Add a BACnet over
Ethernet network in BACstac for KMC
Connect and TotalControl if needed.)
See Ethernet/IP Configuration via
Software on page
• Device Instance = Enter the Device Instance.
• Baud Rate = Select MS/TP baud rate selection
(9600 to 115200).
• MAC Address = Enter the MAC address (on
MS/TP models).
• Comm Type = Select IP or Ethernet (on
Ethernet models).
• IP Mode = Select Normal or Foreign Device.
• IP Address = Enter the IP address.
• Gateway Address = Enter the Gateway
address.
• Subnet Mask = Enter the Subnet mask.
• UDP Port = Enter the FlexStat's UDP port.
• BMDP Port = Enter the UDP Port of the BBMD
to which the FlexStat is registering as a foreign
device.
• BBMD Address = Enter the remote BBMD IP
address.
• Foreign Time To Live = Enter the Interval (in
seconds) at which the FlexStat (if set as a
foreign device) sends a registration message
to the BBMD with which it is registered.
BAC-19xxxx FlexStat Application Guide
9.
7.

Schedule (Menu Options)

NOTE: If no schedule is set, the FlexStat will
remain in continuous occupied state as
a default.
• Setpoint Hold = Select to run the Schedule or
Hold the current setpoint.
• Entire Week = Set a schedule that applies to all
seven days.
• Weekdays = Set a schedule that applies to
Monday through Friday (only).
• Weekend = Set a schedule that applies to
Saturday and Sunday (only).
• Individual Days = Set a schedule that applies
to designated days only.
• Holidays = Set a schedule that applies to
designated holidays.

Set Clock (Menu Options)

• Date = Set the date for initial or stand-alone
operation.
• Time = Set the time for initial or stand-alone
operation.
• UTC-Offset = Set the optional UTC offset for
the relevant time zone (see
Offset Time Zones on page
• DST Enable = Manually turn on/off Daylight
Saving Time mode.
• DST Auto = Enable/disable automatic Daylight
Saving Time mode.

Setpoints (Menu Options)

• Occupied Cooling = Set the Occupied Cooling
setpoint.
• Occupied Heating = Set the Occupied Heating
setpoint.
• Unoccupied Cooling = Set the Unoccupied
Cooling setpoint.
5
Appendix: UTC
25).
AG200824A