Remembering Remote Control Codes From Other Devices - Marantz SR7010 Owner's Manual

Contents Connections
Remembering remote control codes
from other devices
1
Place the Marantz remote control and remote control
from the other device approximately 5 cm apart, with
the remote control signal transmission sections facing
each other.
2
Press and hold SET until the LEARN indicator blinks.
3
Press input source select buttons to select the input
source.
The input source is shown in the remote control display.
4
Select the button to be learned.
LEARN indicator lights up.
5
Press and hold the button that you want to register on
the other remote control until "OK" is displayed on the
Marantz remote control display.
If "NG" is shown on the remote control display, perform step 4
0
again.
Front panel Display
Playback Settings
6
Repeat steps 4 and 5 to learn other buttons for the
same input source.
7
When programming of the remote control unit is
completed, press SET.
The LEARN indicator turns off, and the remote control unit exits
learn mode.
0 There are some remote control units that cannot be programmed, or even if they
can be programmed, they may not operate correctly. If this happens, use the
remote control unit supplied with the AV equipment to operate it.
0 If the remote control memory becomes full, "FULL" is shown on the remote control
display. If you want to learn the code, you should erase other learned button.
NOTE
0 The learning function is unavailable for all ZONE SELECT, SET, AVR, POWER X,
VOLUME df, SMART SELECT, SOUND MODE and input source select buttons
in any mode.
0 If no buttons are pressed for approximately 1 minutes while in the LEARN mode,
the remote control unit automatically exits from the LEARN mode.
302
Rear panel
Tips
Remote Index
Appendix