Decode Mode - Marantz SR7010 Owner's Manual

Contents Connections
Input Select
Set the audio input mode and decode mode of each input source.
The input modes available for selection may vary depending on the input
source.
0 "Input Select" settings are stored for each input source.
o Input Mode
Set the audio input modes for the different input sources.
It is normally recommended to set the audio input mode to "Auto".
Auto
(Default):
HDMI:
Digital:
Analog:
7.1CH IN:
0 When digital signals are properly input, the ~ indicator lights on the display.
If the ~ indicator does not light, check "Input Assign" and the connections.
(v p. 233)
0 If "HDMI Control" is set to "On" and a TV compatible with the ARC is
connected via the HDMI MONITOR 1 connectors, the input mode whose input
source is "TV Audio" is fixed to ARC.
0 The sound mode cannot be set if the input mode is set to "7.1CH IN".
Front panel Display
Playback
Automatically detect input signal and
perform playback.
Play only signals from HDMI input.
Play only signals from digital audio input.
Play only signals from analog audio input.
Only signals input from the 7.1CH IN
connector will be played back.
Rear panel
Settings
o Decode Mode
Set the audio decode mode for input source.
It is normally recommended to set the audio input mode to "Auto". But
we recommend changing it to "PCM" or "DTS" if the start of the source
is clipped or noise occurs.
Auto
(Default):
PCM:
DTS:
0 This item can be set for input sources for which "HDMI" or "DIGITAL" is
assigned at "Input Assign". (v p. 233)
Upgrade (Auro-3D)
Auro-3D:
0 This item can always be set on models supporting Auro-3D.
0 The sound modes you can select are Auro-3D or Auro-2D Surround when the
"Decode Mode" setting is "Auro-3D".
237
Remote
Tips Appendix
Detect type of digital audio input signal
and decode and play automatically.
Decode and play only PCM input signals.
Decode and play only DTS input signals.
The input signal is decoded using an
Auro-3D decoder.
Index