Levels - Marantz SR7010 Owner's Manual

Contents Connections
o Dolby Speaker Setup
Set the distance between the Dolby Atmos Enabled speaker and the
ceiling.
3.0 ft - 11.0 ft / 0.90 m - 3.30 m(Default : 6.0 ft / 1.80 m)
0 This can be set when "Front Dolby", "Surround Dolby" or "Back Dolby" is set to
"Large" or "Small" in "Speaker Config.".
o Set Defaults
The "Distances" settings are returned to the default settings.
Front panel Display
Playback Settings

Levels

Set the volume of the test tone to be the same at the listening position
when it is output from each speaker.
o Test Tone Start
A test tone is output from the selected speaker.
While listening to the test tone, adjust the volume output from the
selected speaker.
–12.0 dB – +12.0 dB (Default : 0.0 dB)
0 The set "Levels" are reflected in all sound modes.
0 If you wish to adjust the channel level for each input source, carry out the
settings in "Channel Level Adjust". (v p. 157)
0 When headphones are connected to the PHONES connector on this unit, you
cannot set "Levels".
o Set Defaults
The "Levels" settings are returned to the default settings.
264
Rear panel
Tips
Remote Index
Appendix