Appearance Of Battery Module; Backup Time Of Standard Battery Module For Single Ups - Emerson Liebert ITA User Manual

1. The battery loop and the AC input are not insulated, so the hazardous voltage may exist between the battery port and the
earth. Never touch them by hand to avoid electrical shock.
2. See Figure 2-25 and Figure 2-26 for the appearance and the length of the battery cable (battery module accessory). If the
longer cables are needed, please contact the dealers.

8.2.2 Appearance Of Battery Module

The appearance of the battery module is shown in Figure 8-1.
There is no operation and display panel on the front panel of the battery module. The plastic panel can be removed
and adjusted according to actual requirement, as shown in Figure 8-2.
The battery module provides ventilation holes, battery ports and battery fuse box on the rear panel, as shown in
Figure 8-3.

8.2.3 Backup Time Of Standard Battery Module For Single UPS

For U16-07C1 battery module, when it is at full load (18kW), the backup time of four battery modules is about five
minutes, and backup time of ten battery modules is about 30 minutes. When it is at half load (9kW), the backup time
of four battery modules is about 15 minutes, and backup time of ten battery modules is about an hour. See Table 8-3
and Table 8-4 for details.
Figure 8-1 Appearance of the battery module
Plastic panel
Figure 8-2 Removing the plastic panel
Battery fuse box
Ventilation hole Battery port 1
+ -
注意：为避免着火的危险，请用同种容量和型号的保险替换
CAUTION-For Continued Protection
Replace Only With Fuse of The Sa
Figure 8-3 Rear panel of the battery module
Liebert ITA 16kVA And 20kVA UPS User Manual
®
Note
Battery port 2
+ -
保险
F 32AH 400Vdc
Against Risk of Fire ，
me Type and Rating .
Chapter 8 Options 57