Emerson Liebert itON 1500 Quick Start Manual

I S I
MPORTANT AFETY NSTRUCTIONS
1 B
Read SAFETY INSTRUCTIONS sheet first.
S
ETUP
S tep 1
4 B
Inspect the Package
Inspect the package and the UPS upon receipt.
Notify the carrier and dealer of visible damage.
S tep 2
5 B
Decide Where to Place the UPS
The UPS must be placed indoors, protected from
water, direct sunlight and excessive heat.
Provide at least 7.8" (20 cm) of clearance on all
sides of the unit for proper ventilation.
S tep 3
6 B
Charge the UPS Battery Before Use
The UPS battery is fully charged before shipping.
However, some charge may be lost during shipping
and the battery should be recharged prior to use.

Plug in the AC input cord (supplied) to the wall
outlet. For the best results, suggest to charge
the battery at least 6 hours before initial use.
The unit charges its battery while connecting
to the utility.
S tep 4
7 B
Start the UPS
After the battery is fully charged:

Turn on the UPS by pressing the On/Off
button.
LED1 should be illuminated (green), indicating the
UPS is operating in Normal mode.
S tep 5
8 B
Connect the Loads
The UPS has six battery backup outlets that provide
power when the UPS operates on battery. (see
Figure 2 on next page)

Plug the loads into the battery backup outlets
on the rear of the UPS.
CAUTION: NEVER connects a laser printer or
scanner to the UPS unit. This may cause the damage
of the unit.
Step 6
Connect the Network Surge Protection
The UPS has two RJ-11 jacks for network lines.

Connect a single-line network cable into the
RJ-11 network surge protection IN jack on the
rear of the UPS.

Connect a RJ-11 cable from the OUT jack on
the rear panel of the UPS to a port on a PC or
network device such as a router.
Step 7
Set Up Shutdown Software
To start using shutdown software:

Install the shutdown software on supplied CD.
Follow on screen instructions to install the
software.

Connect one end of USB cable (supplied) to
the USB port on the rear panel of the UPS.
Connect the other end of USB cable on the
computer USB port.

See the software user manual for detailed
operation inside of supplied CD.
1
Liebert
Quick-Start Guide – 1500VA/2000VA, 230V
UPS
®
itON
Quick-start Safety Quick-start guide
guide Instructions (all languages)
USB cable Input Cable
10H52200GM60 – Rev. 5 – 06/2014