Table of Contents
Advertisement
Chassis Service Information
Static-Sensitive Devices
Precautions
007-5839-001
•
You should be using registered ECC DDR3 memory. Also, it is recommended that you use
the same memory type and speed for all DIMMs in the system.
•
Contact your administrator or support provider if the memory errors continue.
The following sections cover the steps required to install components and perform maintenance
on the C1104G-RP5 chassis. For component installation, follow the steps in the order given to
eliminate the most common problems encountered. If some steps are unnecessary, skip ahead to
the step that follows.
Important: Always disconnect the AC power cord(s) before adding, changing or installing any
internal hardware components.
Tools Required: The only tool you will need to install components and perform maintenance is
a Phillips screwdriver.
Electrostatic discharge (ESD) can damage electronic components. To prevent damage to any
printed circuit boards (PCBs), it is important to handle them very carefully. The following
measures are generally sufficient to protect your equipment from ESD damage.
•
Use a grounded wrist strap designed to prevent static discharge.
•
Touch a grounded metal object before removing any board from its antistatic bag.
•
Handle a board by its edges only; do not touch its components, peripheral chips, memory
modules or gold contacts.
•
When handling chips or modules, avoid touching their pins.
•
Put the serverboard, add-on cards and peripherals back into their antistatic bags when not in
use.
Chassis Service Information
43
Advertisement
Table of Contents
