Table of Contents
Advertisement
4.
Electrical Safety Precautions
007-5839-001
Chapter 4
System Safety
This chapter describes basic safety precautions when using the server.
Basic electrical safety precautions should be followed to protect yourself from harm and the
Rackable C1104G-RP5 system from damage, as follows:
•
Be aware of the locations of the power on/off switch on the chassis as well as the room's
emergency power-off switch, disconnection switch or electrical outlet. If an electrical
accident occurs, you can then quickly remove power from the system.
•
Do not work alone when working with high voltage components.
•
Power should always be disconnected from the system when removing or installing main
system components, such as the memory modules and disk drives. When disconnecting
power, you should first power down the operating system and then unplug the power cords.
The unit can have more than one power supply cord. Disconnect two power supply cords
before servicing to avoid electrical shock.
•
When working around exposed electrical circuits, another person who is familiar with the
power-off controls should be nearby to switch off the power if necessary.
•
Use only one hand when working with powered-on electrical equipment. This is to avoid
making a complete circuit, which will cause electrical shock. Use extreme caution when
using metal tools, which can easily damage any electrical components or circuit boards they
come into contact with.
•
Do not use mats designed to decrease static electrical discharge as protection from electrical
shock. Instead, use rubber mats that have been specifically designed as electrical insulators.
•
The power supply power cords must include a grounding plug and must be plugged into
grounded electrical outlets or power distribution unit (PDUs).
27
Advertisement
Table of Contents
