Hilti SID 14­A Operating Instructions Manual page 23

7.5 Driving screws and tightening bolts
7.5.1 Fitting the bit / bit holder
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Fit the appropriate insert tool in the chuck.
en
7.5.2 Screwdriving
WARNING
Ensure fastener and attachment will withstand the level of torque
generated by the tool. Excessive torque may overstress, strip or damage
the fastener/attachment and possibly lead to personal injury.
1. Set the forward / reverse switch to the desired direction of rotation.
2. Set the torque selector switch to the desired torque.
7.6 Reading the charge status LED display on Li­ion batteries
NOTE
The charge status cannot be indicated while the power tool is in operation. If
LED 1 blinks, this merely indicates that the battery is either fully discharged
or is too hot (temperature above 80°C (176°F)).
The Li-ion battery features a charge status LED display. The charge status
is indicated by the LEDs on the battery during charging (please refer to the
section "Li-ion battery charge status"). When the battery is at rest (not in
use), its charge status is indicated by the four LEDs on the battery for a time
of three seconds after pressing one of the battery release buttons.
7.7 Belt hook
CAUTION
Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by the
operator. The belt hook can also be fitted to the other side of the power tool
for use by left-handed persons.
1. Pull the battery out of the tool.
2. Fit the mounting plate into the guides provided.
3. Secure the belt hook with the two screws.
18
Printed: 30.09.2013 | Doc-Nr: PUB / 5070695 / 000 / 02
9
8