Operation - Hilti SID 14­A Operating Instructions Manual

6.4 Removing the battery
1. Press one or both release buttons.
2. Pull the battery out of the power tool toward the rear.
6.5 Transport and storage of battery packs
en
Pull the battery pack out of the locked position (working position) and move
it into the first click-stop position (transport position).
If you disconnect a battery pack from the power tool for transport or storage,
make sure that the contacts of the battery pack are not short-circuited.
Remove loose metal parts such as screws, nails, clamps, loose screw bits,
wires or metal swarf from the case, toolbox or transport container, or prevent
these parts from coming into contact with the battery packs.
Observe national and international transport regulations when shipping
battery packs (transportation by road, rail, sea or air).

7 Operation

7.1 Changing insert tools
CAUTION
Wear protective gloves when changing insert tools as the insert tools
get hot during use.
Check that the connection end of the insert tool is clean.
connection end if necessary.
7.1.1 Changing insert tools with the SID 14-A and SID 18-A
NOTE
The power tool is equipped with a ¹/₄" hex. socket chuck with locking ring.
7.1.1.1 Fitting the screwdriving bit
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Push the bit into the chuck as far as it will go (until it engages).
7.1.1.2 Removing the screwdriving bit
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the locking ring on the chuck forward and hold it in this position.
3. Pull the screwdriving bit out of the chuck and then release the locking
ring.
16
Printed: 30.09.2013 | Doc-Nr: PUB / 5070695 / 000 / 02
2
3
4
Clean the