Keypad Commands - ESP Enterview 5 Instructions Manual

Keypad Commands

Default master code: 1234
Entering Programming mode
1 Press * then 4 digit master code
2 If successful three tones will sound and the LED will flash
Adding user codes
1 Enter programming mode
2 lnput the code group O1-31 for normal operation, 32-40 for latching mode.
3 Enter the 4 digit code, if successful three tones sound if not 2 tones sound.
4 Press* to exit
Deleting a user code
1 Enter programming mode
2 Enter group code O1-40
3 Press # to delete code
4 If successful three tones will sound
5 Press * to exit
Deleting a code from an unknown group
1 Enter programming mode
2 Press # two tones will sound
3 lnput 4 digit code to be deleted
4 Three tones will sound if successful
5 Press * to exit
Deleting all codes
1 Enter programming mode
2 Press # two tones will sound
3 Press # again to hear a further two tones
4 Press # seven times to default all codes and settings (the master code will remain)
5 The system will resume after five seconds
Changing the master code
1 Down power the unit
2 Press and hold *, power up the unit, a long tone will sound, release *
3 When the tone stops a short tone will sound, the new 4 digit master/programming
code can be input
Set the lock time
1 Enter programming
2 Enter O0
3 Enter the lock/delay operation time (O1-99 seconds)
4 Press * to exit
8