Mitsubishi ECLIPSE Owner's Manual page 299

Comfort controls
NOTE
When the " " or "
turn the air conditioning off or use the recirculation posi-
tion.
This prevents the windows from fogging up.
When the mode selection dial is set to a position other
than " " or "
change to outside air. The air conditioning will revert to
the previous condition in which the "
tion was not selected.
When the temperature control dial is set to the "MAX
A/C" position, the air selection will be automatically set
to the recirculation position.
If the temperature dial is set to any position other than
"MAX A/C", outside air will always be used when the
ignition switch is turned on.
When the coolant temperature rises above a certain point,
the air selection is automatically switched to the recircula-
5
tion position and the indicator light (A) turns on. When
this occurs, the system will not switch to the outside air
position until the coolant temperature goes down, even if
the selection switch is pushed.
5-8
" position is selected, you cannot
", the air selection will automatically
" or "
Air conditioning switch
Push the switch, and the air conditioning compressor will turn
on. The air conditioning indicator light (A) will come on.
" posi-
Push the switch again and the air conditioning compressor will
stop and the indicator light (A) goes off.
CAUTION
!
Using the air conditioning slightly increases the
engine idle speed. Therefore, make sure your foot is
firmly on the brake pedal when shifting the tran-
saxle into drive.
(Green)
N00731000319