Mitsubishi ECLIPSE Owner's Manual page 160

CAUTION
!
Release the ignition key as soon as the engine starts.
Otherwise, the starter motor will be damaged.
Starting the engine
Your vehicle is equipped with an electronically controlled fuel
injection system, which automatically controls the release of
fuel. There is usually no need to depress the accelerator pedal
when starting the engine.
The starter should not be run for more than 15 seconds at a
time.
To prevent battery drain, wait a few seconds between attempts
to restart the engine.
Normal conditions
To start your vehicle:
Make sure all occupants are properly seated with seat belts fas-
tened.
1. Insert the ignition key.
2. Make sure the parking brake is applied.
3. Press and hold the brake pedal down with your right foot.
4. Press and hold the clutch pedal all the way down (manual
transaxle).
NOTE
For models equipped with a manual transaxle, the starter
will not operate unless the clutch pedal is fully depressed
(Clutch interlock). This is a safety feature.
5. On vehicles with manual transaxle, place the gearshift
lever in the "N" (Neutral) position.
On vehicles with automatic transaxle, make sure the
selector lever is in the "P" (PARK) position.
6. Turn the ignition key to the "ON" position and make cer-
tain that all warning lights are functioning properly before
starting the engine.
7. Turn the ignition key to the "START" position without
pressing the accelerator pedal. Release the key when the
engine starts.
NOTE
Minor noises may be heard on engine start-up. These will
disappear as the engine warms up.
Features and controls
3
3-65