Mitsubishi ECLIPSE Owner's Manual page 68

5. After confirming that the belt is locked, grab the shoulder
part of the belt near the buckle and pull up to remove any
slack from the lap part of the belt allowing the slack to
feed into the retractor. Remember, if the lap belt portion is
not tight, the child restraint system will not be secure. It
may help to put your weight on the child restraint system
and/or push on its seatback while pulling up on the belt
(see illustration).
In an ECLIPSE, if your child restraint system requires the use of
a tether strap fasten the tether strap in accordance with steps 6 to
8 shown hereafter.
6. Open the rear hatch. Remove the rear shelf panel (if so
equipped). Refer to "Rear shelf panel" on page 3-180.
7. Cut out the notch (A) in the cargo floor carpet by hand,
then lift the carpet.
* - Rear of the vehicle
Seat and restraint systems
2
2-33