Configuration > Qinq > Qinq Settings - D-Link DGS-1210/ME User Manual

4 Configuration
Join Time (100-100000): Indicates the time in milliseconds that PDUs are transmitted. The default value is
200ms.
Leave Time (100-100000): Indicates the amount of time in milliseconds that the device waits before leaving
its GARP state. The leave time is activated by a leave all time message sent/received, and cancelled by the
Join message. The default value is 600ms.
Leave_All Time (100-100000): Used to confirm the port within the VLAN. The time in milliseconds between
messages sent. The default value is 10000ms.
Click Apply to implement changes made.
Configuration > QinQ > QinQ Settings
The QinQ Settings page allows user to enable or disable the Q-in-Q function. Q-in-Q is designed for service
providers to carry traffic from multiple users across a network.
Q-in-Q is used to maintain customer specific VLAN and Layer 2 protocol configurations even when the same
VLAN ID is being used by different customers. This is achieved by inserting SPVLAN tags into the
customer's frames when they enter the service provider's network, and then removing the tags when the
frames leave the network.
Customers of a service provider may have different or specific requirements regarding their internal VLAN
IDs and the number of VLANs that can be supported. Therefore customers in the same service provider
network may have VLAN ranges that overlap, which might cause traffic to become mixed up. So assigning a
unique range of VLAN IDs to each customer might cause restrictions on some of their configurations
requiring intense processing of VLAN mapping tables which may exceed the VLAN mapping limit. Q-in-Q
uses a single service provider VLAN (SPVLAN) for customers who have multiple VLANs. Customer's VLAN
IDs are segregated within the service provider's network even when they use the same customer specific
VLAN ID. Q-in-Q expands the VLAN space available while preserving the customer's original tagged packets
and adding SPVLAN tags to each new frame. Select Enabled or Disabled then click Apply to enable or
disable the Q-in-Q Global Settings.
From Port / To Port: A consecutive group of ports that are part of the VLAN configuration starting with the
selected port.
Role: The user can choose between UNI or NNI role.
UNI – To select a user-network interface which specifies that communication between the specified
user and a specified network will occur.
NNI – To select a network-to-network interface specifies that communication between two specified
networks will occur.
Outer TPID (hex: 0x1-0xffff): The Outer TPID is used for learning and switching packets. The Outer TPID
constructs and inserts the outer tag into the packet based on the VLAN ID and Inner Priority.
Trust CVID: Specify the Trust CVID is enabled or disabled on the ports.
VLAN Translation: Specify the VLAN Translation is enabled or disabled on the ports.
Click Apply to implement changes made.
DGS-1210 series Metro Ethernet Managed Switch User Manual
Figure 4.59 - Configuration > QinQ > QinQ Settings
34