System > Smtp Service > Smtp Service; System > D-Link Discover Protocol Settings - D-Link DGS-1210/ME User Manual

4 Configuration
DGS-1210 series Metro Ethernet Managed Switch User Manual
Figure 4.45 - System > SMTP Service > SMTP Server Settings
SMTP State: Enabled or Disabled the SMTP service on this device.
SMTP Server Address: Select IPv4 or IPv6 and enter the IP address of the SMTP server on a remote
device. This will be the device that sends out the mail for user.
SMTP Server Port: Enter the virtual port number that the Switch will connect with on the SMTP server. The
common port number for SMTP is 25, yet a value between 1 and 65535 can be chosen.
Self Mail Address: Enter the e-mail address from which mail messages will be sent. This address will be the
"from" address on the e-mail message sent to a recipient. Only one self mail address can be configured for
this Switch. This string can be no more that 64 alphanumeric characters.
Mail Receiver Address: Enter a list of e-mail addresses so recipients can receive e-mail messages
regarding Switch functions. Up to 8 e-mail addresses can be added per Switch. Do delete these addresses
from the Switch, click Delete button from the Mail Receiver Address Table.
System > SMTP Service > SMTP Service
The SMTP Service is used to send test messages to all mail recipients configured on the Switch, thus testing
the configurations set and the reliability of the SMTP server.
Figure 4.46 - System > SMTP Service > SMTP Service
Subject: Enter the subject of the test e-mail.
Content: Enter the content of the test e-mail.
Once the message is ready, click Send to send this mail to all recipients configured on the Switch for SMTP.
System > D-Link Discover Protocol Settings
For the D-Link Discovery Protocol (DDP) supported device, this page is an option for you to disable DDP or
configure the DDP packet report timer.
D-Link Discover Protocol State: The default setting is Disabled. Select Enabled then click Apply to turn on
D-Link Discover Protocol State.
28