Poe > Poe System Settings (Dgs-1210-28P Only) - D-Link DGS-1210/ME User Manual

4 Configuration
From Port/To Port: Specifies the PoE function of a port or ports.
State: Select "Enabled" or "Disabled" to configure PoE function for designated port(s). Default is Enabled.
Time Range: Select the PoE time profile configured from Time-Based PoE > Time Range Settings to enable
the time-based PoE function on designated port(s). Default setting is N/A.
Priority: Configure the power supply priority as "Low", "Normal", or "High" on designated port(s). Default is
Normal.
Power Limit: This function allows you to manually set the port power current limitation to be given to the PD.
To protect the DGS-1210-10P/28P and the connected devices, the power limit function will disable the PoE
function of the port when the power is overloaded. Select from "Class 1", "Class 2", "Class 3", "Class 4"
and "Auto" for the power limit. "Auto" will negotiate and follow the classification from the PD power current
based on the 802.3at standard.
User Define: Check the box and input the power budget (from 1 to 30W) to manually assign an upper limit of
port power budget on designated port(s).
Click Apply to make the configurations take effects or click Refresh to redisplay the table.
PoE > PoE System Settings (DGS-1210-28P only)
This page will display the PoE status including System Budget Power, Support Total Power, Remainder
Power, and The ratio of system power supply.
DGS-1210 series Metro Ethernet Managed Switch User Manual
Figure 4.187 – PoE > PoE Port Settings
Note: For the PoE Port Settings table, if the
classification was shown as "Legacy PD", it will be
classified to non-AF PD or Legacy PD.
110