System > Port Configuration > Port Settings; System > Port Configuration > Port Description - D-Link DGS-1210/ME User Manual

4 Configuration
Firmware Upgrade State: Information of firmware upgrade - success or failure.
Port Security Violation: Events of port security violation.
IMPB Violation: Specifies the device to send notifications when IMPB violation detected.
Loopback occurring/recovery: Specifies the device to send notifications when loopback occurring /
recovery.
DHCP Server Screening: Specifies the device to send notifications when DHCP server screening.
Gratuitious ARP: Specifies the device to send notifications when duplicate IP were detected.
System > Port Configuration > Port Settings
In the Port Setting page, the status of all ports can be monitored and adjusted for optimum configuration. By
selecting a range of ports (From Port and To Port), the Speed can be set for all selected ports by clicking
Apply. Press the Refresh button to view the latest information.
Media: Depending on the selected port type, two options for user. Copper and Fiber_1G.
State: Enable or disable the state of specified ports.
Speed: Gigabit Fiber connections can operate in 1000M Full Force Mode, Auto Mode or Disabled. Copper
connections can operate in Forced Mode settings (1000M Full, 100M Full, 100M Half, 10M Full, 10M Half),
Auto, or Disabled. The default setting for all ports is Auto.
MDI/MDIX:
A medium dependent interface (MDI) port is an Ethernet port connection typically used on the Network
Interface Card (NIC) or Integrated NIC port on a PC. Switches and hubs usually use Medium dependent
interface crossover (MDIX) interface. When connecting the Switch to end stations, user have to use
straight through Ethernet cables to make sure the Tx/Rx pairs match up properly. When connecting the
Switch to other networking devices, a crossover cable must be used.
This switch provides a configurable MDI/MDIX function for users. The switches can be set as an MDI port in
order to connect to other hubs or switches without an Ethernet crossover cable.
Auto is designed on the switch to detect if the connection is backwards, and automatically chooses MDI or
MDIX to properly match the connection. The default setting is "Auto" MDI/MDIX.
Flow Control: You can enable this function to mitigate the traffic congestion. Ports configured for full-duplex
use 802.3x flow control, half-duplex ports use backpressure flow control. The default setting is Disabled.
System > Port Configuration > Port Description
In the Port Description page, the user may name various ports on the Switch.
DGS-1210 series Metro Ethernet Managed Switch User Manual
Figure 4.20 – System > Port Configuration > Port Settings
NOTE: Be sure to adjust port speed settings
appropriately after changing the connected cable
media types.
1 7
1 7