AT&T 7407 User Manual page 16

To program/reprogram an
outside number,
extension, or feature code
into a personal list
To place a call using an
AD list button or code
1 On a separate sheet of paper, jot down the outside
numbers, extensions, and/or feature codes you want to
program as items on your personal lists(s) (see example
to the left)
Note: Each phone number or feature code is stored as
a separate item.
2 Pick up handset
Note: If you are using the built-in speakerphone, you
must press a call appearance button before you
proceed to Step 3.
3 Press [
Program
or Dial AD Program code
Press [
4
Personal List
or Dial Personal List code (1, 2, or 3)
Dial list item (1, 2, 3...)
5
6 Dial number you want to store (up to 24 digits)
Press [ ]
7
#
Repeat Steps 5-7 if you want to program
additional items on the same list; press [
and begin again at Step 1 if you want to program
items on another list
8
Hang up or press [
Note: Record your personal list items on the
Abbreviated Dialing list in the back of this booklet;
group, system, and enhanced lists can be obtained
from your System Manager.
1
Press [
Personal List
or Dial appropriate AD List code:
List 1
List 2
List 3
Note: An [
Enhanced List
your System Manager.
2
Dial desired list item (1, 2, 3...)
Call is dialed
]
]
] to end programming
Drop Test
] or [
Group List
] may also be available; see
[dial tone]
[dial tone]
[dial tone]
[dial tone]
[confirmation tone]
]
Drop Test
] or [ ]
System List
[dial tone]
[ringback tone]
12