Barco Nio E-2621 Getting Started Manual page 28

Installing your Barco display controller
Align the display controller(s) for your B
7.
with the slot(s) and press it(them) in firmly until the card(s)
is(are) fully seated.
Note: This step applies only to the MXRT 5100 and MXRT 7100.
8.
Connect the power cable to the 6-pin power connection on the
graphics card. Make sure the cables are not interfering with
anything inside the computer (for example, a cooling fan).
Figure 6: Power connection for the MXRT 5100 and 7100 controllers
Screw in or fasten the display controller securely. Replace and
9.
secure the computer cover.
Connect your Nio displays to the display controller(s) for your
10.
B N Display System using the cables supplied. Make sure all
ARCO IO
cables are securely connected before turning on your system.
Figures 7 and 8 show the types of connections are available:
28
N Display System
ARCO IO
6-pin graphics controller
power cable
Nio display systems