Guest Network - TP-Link Archer CR700 User Manual

Archer CR700

Note:
1) The WPS LED on the modem router will light green for five minutes if the device has been
successfully added to the network.
2) The WPS function cannot be configured if the Enable Router's PIN switch is off. Please
make sure the Enable Router's PIN switch is on before configuring the WPS.

5.4.3 Guest Network

Choose menu "Advanced → Wireless 2.4G → Guest Network", you can configure the
advanced settings of your guest network.
Settings:
See each other - If Allow guests to see each other is selected, anyone who connects to the

guest network can access each other.
Access my local network - If Allow guests to access my local network is selected,

anyone who connects to the guest network has access to your local network, not just Internet
access.
Wireless:
Wireless radio – Check the box to enable this function. The guest network function is

disabled by default.
Name (SSID) - Create a name for the guest network. When setting up a Guest network, it is

strongly recommended to use a name that easily distinguishes it from your primary network.
AC1750 Wireless Dual Band DOCSIS Cable Modem Router User Guide
Figure 5-19
43