Sena Parani MSP1000 User Manual page 56

 Automatic firmware and configuration upgrade at boot time
It determines whether the Parani- MSP1000 upgrade at boot time or not.
 Protocol
It determines which protocol the Parani-MSP1000 uses to communicate with the remote host on
upgrading.
 IP address of remote server
It determines to which host the Parani- MSP1000 connects to get the hash file, firmware image
and configuration file.

Hash file name
It determines the name of hash file that is used to specify the firmware image file and
configuration file to upgrade. The Parani-MSP1000 checks if the Parani-MSP1000 needs to
upgrade or not by comparing the version at hash file with the Parani-MSP1000 firmware version.
Hash file format is below:
①
Firmware upgrade : <TYPE>,<NAME>,<VERSION>
<TYPE> - 1
<NAME> - the name of firmware image.
<VERSION> - the version of firmware
②
Configuration upgrade : <TYPE>,<NAME>,<OPTION>,<VERSION>
<TYPE> - 2
<NAME> - the name of configuration file
<OPTION> - [E][N]
E : Encrypted configuration file
N : Non-encrypted configuration file
<VERSION> : the version of configuration file
③
User file upload : <TYPE>,<NAME>,<OPTION>,<PATH>
<TYPE> - 3
<NAME> - the name of target file
<OPTION> - [F][X][Z]
F : forced copy (remove if there is same file already)
X : uncompress the file to the specified location
Z : unzip the file to the specified location
<PATH> - Directory path where the specified file will be uploaded
④
User command run : <TYPE>,<COMMAND>
<TYPE> - 4
<COMMAND> - command to run
56