Pairing Mode - Acceptor; Pairing Mode - Custom; Port Configuration - Sena Parani MSP1000 User Manual

 Scan interval
The Parani-MSP1000 scans neighborhood Bluetooth devices with this interval (in seconds). This
value means the time required for the Parani- MSP1000 to recognize a new device.
Note: Too short interval may make the data rate slow.
 Scan mode
Parani-MSP1000 scans with IAC or Bluetooth friendly name.
 Inquiry access code (IAC)
The Parani-MSP1000 scans nearby Bluetooth devices with this IAC. The IAC should be in range
from 9e8b00 to 9e8b3f (in hexadecimal). Most of Bluetooth devices are set up as generic IAC
(9e8b33). To connect to the devices, the IAC should be generic IAC. However, when the IAC is
generic, it is possible the Parani- MSP1000 finds too many Bluetooth devices to connect. If then, it
is efficient to use limited IAC or user -defined IAC. To use non-generic IAC, the IAC of Bluetooth
device to which the Parani-MSP1000 connect should also be changed.
 Remote device name
The Parani-MSP1000 attempts to connect to the devices whose name start with the configured
name.

5.3. Pairing mode - Acceptor

The Parani-MSP1000 accepts all incoming connections.

5.4. Pairing mode - Custom

The Parani-MSP1000 communicates with only the registered Bluetooth devices. When using this
mode, the detail configuration is prepared in the Port configuration. Please, refer to 5.5 Port
configuration.

5.5. Port configuration

The Port configuration has different submenus according to the Pairing mode. The Port pairing mode
menu and Logging menu are prepared only when the Pairing mode is "Custom".
35