Automatic Firmware Upgrade - Sena Parani MSP1000 User Manual

-------------------------------------------------------------------------------
System administrator
-------------------------------------------------------------------------------
1. Device name: MSP1000
2. User management
3. Security
4. Date and Time
5. Configuration management
6. Firmware upgrade
<ESC> Back, <ENTER> Refresh
--> 6
waiting to receive.**B0100000023be50
4. Follow the online directions and transfer the firmware binary file using the Zmodem
protocol.
5. Once the upgrade has been completed, the system will reboot to apply the changes
6. If the firmware upgrade fails, the Parani-MSP1000 will display an error messages. It will
also maintain the current firmware version.
-------------------------------------------------------------------------------
Welcome to MSP1000 configuration page
Current Time : 8/26/2007 06:55:14
F/W Rev. : v1.0.0
IP Mode (eth0) : Static
-------------------------------------------------------------------------------
1. Network configuration
2. System administration
3. System status & log
4. CF card configuration
5. Monitoring
6. Save changes
7. Exit without saving
8. Exit and apply changes
9. Exit and reboot
<ESC> Back, <ENTER> Refresh
--> 2
-------------------------------------------------------------------------------
System administrator
-------------------------------------------------------------------------------
1. Device name: MSP1000
2. User management
3. Security
4. Date and Time
5. Configuration management
6. Firmware upgrade
<ESC> Back, <ENTER> Refresh
--> 6
waiting to receive.**B0100000023be50

7.6.2. Automatic firmware upgrade

To use the function to upgrade the firmware and configuration or to upload a user file or to run a user
command at boot time, users have to set the following properties:
Serial No. : MSP1000 -00001
MAC Addr.(eth 0) : 00:01:95:AF:BE:11
IP Addr.(eth0) : 192.168.11.30
55