LifeGear 97400 Owner's Manual page 11

7
47
8
64
49
53
48
64
Tool:
74
9
Multi Hex Tool with
Phillips Screwdriver
Step 2
Connect the Speed Buttons and Hand Pulse Sensor Wire (48) and Extension Sensor Wire
II (74) from the Right Handlebar (9) to the wires that come from the Computer (49).
Connect the Start/Stop Buttons and Hand Pulse Sensor with Wire (47) from the Left
Handlebar (8) to the wire that comes from the Computer (49).
Install the Computer Bracket (7) to the Left and Right Handlebars (8, 9) by inserting the
Computer Bracket (7) onto the Left and Right Handlebars (8, 9), using four M6x10mm.
Phillips Trim Head Bolts (64). Tighten bolts with the Multi Hex Tool with Phillips
Screwdriver provided.
Place the Safety Tether Key (53) onto the Computer (49).
NOTE: PLEASE FULLY TIGHTEN ALL HARDWARE INSTALLED IN STEP 1 AND
STEP 2 WITH THE TOOLS PROVIDED.
IMPORTANT: While sliding the computer bracket onto the right and left handlebars, make
sure the wires are installed inside the right and left handlebars and pay attention not to
pinch the wires.
Hardware:
(64) M6x10mm. Phillips
Trim Head Bolt
4 PCS
10