Base Molding - Bosch 3912 Operating/Safety Instructions Manual

Saw Operations
Base Molding
Base molding can be cut vertical against fence or flat on • Follow the table for helpful hints on cutting base
the table, molding.
BASE MOLDING CUTTING iNSTRUCTiONS
SETTINGS Vertical Position Horizontal Position
/ Back of molding is Back of molding is flat
INSTRUCTIONS against the fence on the table
Sfiding Fence Far Right Position Move to proper position
Bevel Angle
Molding position
Inside
corner of wall
I
I
I
Outside
corner of wall
Left Side
o
Right Side
Left Side
45 °
Miter Angle Left at 45 ° Right at 45 °
o
Right Side
0 o
Molding Bottom Bottom Top against Bottom
position against table against table fence against fence
Keep left Keep right
side of cut side of cut
Right at 45 ° Left at 45 °
Finished
side
Keep left
side of cut
o
Miter Angle
Keep left
side of cut
o
Molding Bottom Bottom Bottom against Top against
position against table against table fence fence
Finished Keep left Keep right Keep right Keep right
side side of cut side of cut side of cut side of cut
62