Assembling Dust Elbow And Dust Bag - Bosch 3912 Operating/Safety Instructions Manual

Assembly
1.
2.
3.
4.
Assembling Dust Elbow and
Dust Bag
With the miter arm locked in the down position, push
the dust elbow 1 onto the dust nozzle over the tabs
(Figure 5).
The dust bag 2 attaches to the dust chute elbow 1 and is
used to collect sawdust. The dust elbow can also be
attached to a standard 1-1/4" vacuum tube for dust
collection.
Position dust elbow/bag so that it does not interfere with
the tool during the cutting operation for all miter/bevel
settings.
The dust bag requires emptying when full of sawdust.
Empty it frequently and after completion of sawing.
Carefully remove dust bag from dust elbow. Empty dust
bag in proper trash bin by unzipping the bag. Zip the bag
before installing on the dust elbow. Be extremely careful
of dust disposed, materials in fine particle form may be
explosive. Do not throw sawdust on an open fire.
Spontaneous combustion, may in time, result from
mixture of oil or water with dust particles.
r!_b, vAvl'_._ _,1 # II #[€'-! Wh en sawing ch em ically pressu re
treated lumber, paint that may be lead based, or any other
materials that may contain carcinogens, use special
precautions. A suitable respirator must be worn by all
personnel entering the work area. Work area should be
sealed by plastic sheeting and persons not protected should
be kept out until work area is thoroughly cleaned.
2
|
32