Chapter 6: Reference; Connecting A Radio Receiver For Remote Open - HySecurity swingsmart dc 20 Installation And Maintenance Manual

Hide thumbs Also See for swingsmart dc 20:
Table of Contents

Advertisement

This section of the manual provides information which may be useful when installing SwingSmart operators.
It includes how to:
Connect a Radio Receiver for Remote Open
Install a Gate Locking Mechanism
Install a Solar-powered Operator (See NOTE.)
Install Vehicle Detectors and Loops
Install Photoelectric Sensors
Install Gate Edge Sensors
Troubleshoot error codes, faults, and hardware issues
Diagnose vehicle detector and loop faults
Review General Maintenance procedures
C
ONNECTING A
Take the following steps to mount a commercial
style 24VDC radio receiver (external antenna
type):
1. Install the receiver in the channel of the
chassis on either side of the electrical box.
2. Knock out the closest hole in the bottom of
the electrical box and route the wires to the
area marked RADIO OPTIONS. Only
three wire connections are needed because
the common wire and one radio output wire
are connected together. Figure 6-1 shows
additional wires from a two channel receiver.
3. Make sure to observe polarity and crimp
together the black radio common wire and
one of the radio output wires using a ¼-inch
spade connector.
4. Fasten the two crimped wires to the COM
terminal.
5. Connect the red wire to the +24V spade and connect the other radio output contact wire to the spade
marked OPEN.
Revision C
R
R
ADIO
ECEIVER FOR
EDGE
EYE
COM
+ 24 V
EMERG
OPEN
Reference

Connecting a Radio Receiver for Remote Open

Reference
R
SHOW
LEDs
R2
R1
Power
Two Channel Radio Receiver
Figure 6-1.
Chapter 6
O
EMOTE
PEN
Shows connec ons
for Remote Open
and Gate Edge (dashed line).
6-1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Swingsmart dcs 20

Table of Contents