Spinning; Maximum Final Spin Speed; Rinse And Interim Spin; To Omit The Final Spin (Rinse Hold) - Miele PW 5064 Operating And Installation Instructions

Spinning

Maximum final spin speed

Programme
Standard
Standard plus
Thermal disinfection
Chem. therm. disinfection
Cleaning cloths hygiene dis.
Cleaning cloths 40°C/60°C
Pads 40°C
New mops
Curtains
Cottons universal*
Cottons hygiene*
Intensive*
Intensive plus*
Minimum iron*
Quick wash*
Separate rinse
Drain/Spin
* = These programmes are only available if they
have been activated via Settings/Supervisor
level.
You can reduce the final spin speed.
However, you cannot select a final spin
speed higher than that shown in the
chart above.

Rinse and interim spin

There is a spin after the main wash and
between the rinses. A reduction in the
final spin speed will also reduce the
interim spin speed.
18

To omit the final spin (Rinse hold)

^ Select the Rinse hold setting. The
rpm
laundry will not be spun and will
1400
remain suspended in the final rinse
1400
water.
1400
1400 – To start the final spin:
1400
This machine will display the
1400
maximum spin speed possible. You
1400
can select a spin speed lower than
1400
this. Start the final spin by pressing
the Start button.
600
1400
– To end the programme:
1400
Press the Door button. The water will
1400
drain away. Press the Door button
1400
again to open the door.
1000
1400
To omit the spin between rinses and
1400
the final spin
1400
^ Select the Without spin setting. The
water will be pumped away after the
last rinse cycle. At the end of the
programme (with the exception of the
Pads and New mops programmes),
the drum continues to turn at intervals
for up to 30 minutes to maintain
uniform residual moisture throughout
the load and to help prevent
creasing.
The Rinse hold and Without spin
options are not available on the
Thermal disinfection, Chem. therm.
and Cleaning cloths hygiene
programmes.