Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use. If you want to change to wall-
mounting, see Installation options on page 10 for details.
Telephone base installation
Plug one end of the
telephone line cord
into a telephone jack
or a DSL filter.
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Plug the other end
of the telephone line
cord into the telephone
jack on the back of the
telephone base.
Raise the antenna.
Charger installation
IM�ORTANT INFORMATION
•
Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at
1 (800) 222-3111
•
The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Telephone line cord
Plug the other end of
the coiled handset cord
into the jack on the back
of the telephone base.
Plug the power adapter into a power
outlet not controlled by a wall switch.
www.telephones.att.com
. In Canada, dial
6
1 (866) 288-4268
Plug the large end of
the telephone base
power adapter into
a power outlet not
controlled by a wall
switch.
Route the cords through
the channels.
Plug the small end of the
telephone base power
adapter into the power
adapter jack on the back
of the telephone base.
Route the
handset cord
through its
channel.
One end of the coiled
telephone line cord has
already been plugged into
the handset. Make sure it
is plugged in firmly.
or call
.