Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base comes ready for tabletop use. If you want to mount your
telephone on a wall, refer to Wall-mount installation on page 8 for details.
Plug the large end
of the larger power
adapter into an
electrical outlet not
controlled by a wall
switch.
Route the cords
through the slots.
Plug the small end
of the larger power
adapter into the power
jack on the back of the
telephone base.
Plug the large end
of the smaller power
adapter into an
electrical outlet not
controlled by a
wall switch.
Route the cord
through the slot.
Ensure the small end
of the smaller power
adapter is plugged
into the power jack
on the back of the
charger.
IMPORTANT INFORMATION:
1.
Use only the power adapters provided with
this product. To obtain a replacement, visit our
www.telephones.att.com
website at
1 (800) 222-3111
or call
1 (866) 288-4268
In Canada, dial
2.
The power adapters are intended to be correctly
oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place
if it is plugged into a ceiling, under-the-table or
cabinet outlet.
5
Plug one end of the
telephone line cord
into a telephone jack
or a DSL filter.
A DSL filter (not included)
is required if you have
DSL high-speed Internet
service. The DSL filter
must be plugged into the
telephone wall jack.
Telephone line cord
Plug the other end
of the telephone line
cord into the TEL. LINE
jack on the back of the
telephone base.
.
.