Chapter 2 — Set Up the Printer
Run the RFID Calibration Wizard
68
Use one of these methods to calculate Tag Position:
•
Run the RFID wizard.
•
Manually calculate the Tag Position.
Run the RFID calibration wizard to determine the best Tag Position
and Output Power (UHF inlays, only) for RFID media.
Note: After you determine the correct RFID media settings, you can
save these settings to a printer profile and load the profile when you
need to print on the specific RFID media.
1 Make sure the media type and media length are properly
configured.
2 From the Main Menu, select Wizard > Calibration > RFID
Calibration.
3 To enable the RFID module, select Enable.
4 Load the RFID media.
5 Select OK.
When the calibration is complete, the printer displays the RFID
Tag Position and Output Power (UHF inlays, only).
PC23 and PC43 Desktop Printer User Manual