About Tear-Off Printing; Load Media For Tear-Off Printing - Intermec PC23 User Manual

About Tear-Off Printing

Load Media for Tear-Off Printing

PC23 and PC43 Desktop Printer User Manual
In tear-off printing, you manually tear printed labels, tickets,
wristbands, and other printed media from the front of the printer.
After you load media, you need to configure the feed adjust settings.
These settings allow for printing from the top edge of the label. You
may need to adjust the recommended values slightly depending on
your media type, supply method, and roll sizes, or because of
individual differences between printers.
Note: Feed adjust values for simulator command languages like ESim,
ZSim, and DSim are preset.
Recommended Feed Adjust Values for Tear-Off Printing
Printer Setting
PC23d Start Adjust
Stop Adjust
PC43d Start Adjust
Stop Adjust
PC43t Start Adjust
Stop Adjust
Depending on the type of media you use, you may also need to install
a printer accessory. If you need to print on tag media, Intermec
recommends installing the optional thick media springs before
printing. If you need to print on linerless media, you must install the
linerless media roller accessory before printing.
Note: When removing printed labels on linerless media, tear the
label up towards the top of the printer to prevent media jams.
Chapter 2 — Set Up the Printer
203 dpi 300 dpi Distance
-113 -168 -14.24 mm (-0.56 in)
0 0 0 mm (0 in)
-124 -183 -15.50 mm (-0.61 in)
0 0 0 mm (0 in)
-108 -160 -13.60 mm (-0.54 in)
0 0 0 mm (0 in)
37