Table of Contents
Advertisement
6.18.8 Over speed alarm
Set up: Send SMS "speed+password+space+080" to the unit (suppose the speed is 80km/h), and it
will reply "speed OK!". When the target moves exceeding 80km/h, the unit will send SMS
"speed+080!+ latitude & longitude" to the authorized numbers at interval of 3 minutes.
Cancel: Send SMS "nospeed+password" to device.
Remark: The recommended speed should be not less than 30km/h. For below that rate, it will be
effected the accuracy by GPS signals drift etc.
6.18.9 ACC working alarm
6.18.9.1This function is disabled as default. To active this functions, send "ACC+password" to
tracker, it will reply "ACC ok". And tracker will send "ACC on+latitude & longitude" to authorized
numbers when detect ignition action, that means the vehicle has been started; and tracker will send
"ACC off+latitude & longitude" to authorized numbers, that means ACC off.
6.18.9.2 Send "noACC+password" to disabled this function, tracker will reply "noACC ok".
6.18.9.3 This configuration can only enable and disable the alarm to authorized numbers; it will send
to web server automatically in GPRS mode and can't be disabled.
6.19 Cut off the Oil and Power System
6.19.1 Send command "stop+password" to tracker, tracker will execute it and reply "Stop engine
Succeed". And it will remain immobile state until next command to resume.
6.19.2 Stop mode
6.19.2.1Execute immediately: Send command "quickstop+password" to tracker, it will reply
"quickstop OK". Then tracker will stop the car immediately after "stop" command.
6.19.2.2Execute depends on speed(Default mode): Send command "noquickstop+password" to
tracker, It will reply "noquickstop OK", Then the tracker won't stop the car immediately after "stop"
command, instead, it will reply "it will be executed after speed less than 20KM/H", and stop the car
when the speed is less than 20KM/H.
6.19.3 Resume the Oil and Power System
send "resume+password" to tracker, it will reply "Resume engine succeed", that means vehicle has
resume the oil supply.
6.20 Function of Remote Controller (Option, for model B ONLY)
Button
Function
ARM
DISARM
ARM
&
Descriptions
Press for 0.5 second, the siren will beep one time.
Press for 0.5 second, the siren will beep two times.
Press
for
0.5
second
14
when
it
is
in
disarm
state,
the
siren
will
Advertisement
Table of Contents
