CHECKING THE CARBURETOR JOINT/
CHECKING THE FUEL HOSES AND FUEL FILTER
EAS00094
CHECKING THE CARBURETOR JOINT
1. Remove:
• carburetor assembly
Refer to "CARBURETOR" in chapter 6.
2. Check:
• carburetor joint 1
Cracks/damage → Replace.
Refer to "CARBURETOR" in chapter 6.
3. Install:
• carburetor assembly
Refer to "CARBURETOR" in chapter 6.
EAS00097
CHECKING THE FUEL HOSES AND FUEL
FILTER
The following procedure applies to all of
the fuel hoses.
1. Remove:
• fuel pump cover 1
2. Check:
• fuel hose 1
Cracks/damage → Replace.
• fuel filter 2
Contaminants/damage → Replace.
NOTE:
• Drain and flush the fuel tank if abrasive
damage to any components of the fuel
line is evident.
• The arrow mark on the fuel filter must
point towards the fuel pump 3 as shown.
3. Install:
• fuel pump cover
3 - 30
CHK
ADJ
3