Yamaha XV16AL Service Manual page 322

Å
5
ı
CRANKCASE
EAS00386
DISASSEMBLING THE CRANKCASE
NOTE:
Loosen the generator shaft bolt before
removing the generator rotor.
1. Remove:
• generator shaft bolt 1
NOTE:
While the holding the generator rotor 2
with the sheave holder 3, loosen the gen-
erator shaft bolt.
Sheave holder
YS-01880
2. Remove:
• crankcase bolts
NOTE:
• Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern. After all
of the bolts are fully loosened, remove
them.
• Loosen the bolts in decreasing numerical
order (refer to the numbers in the illustra-
tion).
Å Right crankcase
ı Left crankcase
M8 × 100 mm bolts: 1, 2
M8 × 80 mm bolt: 3
M6 × 105 mm bolt: K
M6 × 85 mm bolts: 9, C
M6 × 75 mm bolts: D, E
M6 × 60 mm bolts: 4 ~ 7
M6 × 40 mm bolts: 8, 0 ~ B, F ~ J
3. Turn:
• shift drum segment
NOTE:
Turn the shift drum segment 1 to the posi-
tion shown in the illustration. In this posi-
tion, the shift drum segment's teeth will not
contact the crankcase during crankcase sep-
aration.
5 - 103
ENG