Yamaha XV16AL Service Manual page 193

4
HANDLEBAR
8. Install:
• handlebar grip
▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼
a. Apply a thin coat of rubber adhesive
onto the left end of the handlebar.
b. Slide the handlebar grip over the left end
of the handlebar.
c. Wipe off any excess rubber adhesive
with a clean rag.
WARNING
WARNING
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲
9. Install:
• throttle grip
10.Connect:
• throttle cable
11.Install:
• right handlebar switch
NOTE:
Align the projection a on the right handle-
bar switch with the hole b in the handlebar.
12.Install:
• brake master cylinder
• brake master cylinder holder
NOTE:
• Install the brake master cylinder holder
with the "UP" mark facing up.
• Align the end of the brake master cylinder
holder with the punch mark a in the han-
dlebar.
4 - 71
CHAS
10 Nm (1.0 m · kg, 7.2 ft · lb)