5
CLUTCH
EAS00277
REMOVING THE CLUTCH
1. Remove:
• clutch cable holder 1
• clutch cover 2
NOTE:
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern. After all of
the bolts are fully loosened, remove them.
2. Straighten the lock washer tab.
3. Loosen:
• clutch boss nut 1
NOTE:
While holding the clutch boss 2 with the
universal clutch holder 3, loosen the clutch
boss nut.
Universal clutch holder
YM-91042
4. Remove:
• clutch boss nut 1
• lock washer 2
• clutch boss assembly 3
NOTE:
There is a built-in damper between the
clutch boss and the clutch plate. It is not
necessary to remove the wire circlip 4 and
disassemble the built-in damper unless
there is serious clutch chattering.
EAS00279
REMOVING THE PRIMARY DRIVE GEAR
1. Remove:
• pickup coil rotor bolt 1
5 - 65
ENG