Configure Port
The port configuration screen allows you to change the port
state in the case when you would like to partition a port due to
excessive collision, or for observation, device repair, or security
reasons. Great caution, however, must be observed when
partitioning a port; you should make sure that the partitioned
port is not being used as the port to control or monitor the
condition of other devices.
Figure 6-13. Port Configuration screen
Items in the above window are defined as follows:
♦ Switch
Specifies the Switch where the port is being
configured.
♦ Module
Specifies the module where the port is being
configured.
♦ Port Specifies the port that will be configured.
Using the Console Interface
Stackable NWay Ethernet Switch User's Guide
73