Lcd Gauge (Xt/Xtx) - Arctic Cat 2012 Prowler XT Operator's Manual

LCD Gauge (XT/XTX)

NOTE: All segments of the LCD
will activate for approximately two
seconds when the ignition switch is
rotated to the ON position.
1. Clock/Engine Hour Meter - The clock
function indicates time in the 12-hour
mode; the hour meter indicates the
total time the engine has run and can-
not be reset to zero. To set the clock,
use the following procedure.
A. With the ignition switch ON,
press and release the Mode But-
ton (3) until the Clock/Engine
Hour Meter (1) is displayed; then
(if necessary) press and release
the Set/Reset Button (4) to select
the clock display.
B. Press and hold the Set/Reset But-
ton (4) until the minutes stop
scrolling and the hour display starts
to scroll. Momentarily release
when the correct hour is displayed;
then repeatedly press and release
the Set/Reset Button (4) until the
correct minutes are displayed.
NOTE: Clock memory power is
supplied through the 15-amp acces-
sory fuse and verified during gauge
"power-up" and reset. In the event of
clock memory power failure (blown
fuse, etc.), the gauge will "power-up,"
reset, and shut down repeatedly until
clock memory power is restored.
Always check the 15-amp accessory
fuse if this gauge condition is noted.
NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
2. Temperature Indicator - If the engine
coolant temperature exceeds the nor-
mal operating range, the temperature
icon will begin flashing and the LCD
will go blank for 30 seconds; then the
LCD will return to normal. However,
the temperature icon will continue to
flash.
CAUTION
Continued operation with high engine
temperature may result in engine
damage or premature wear.
NOTE: High engine RPM, low vehi-
cle speed, or heavy load can raise
engine temperature.
HDX192A
engine RPM, reducing load, and
selecting an appropriate transmis-
sion gear can lower the temperature.
NOTE: Debris in front of the
engine (or packed between the
cooling fins of the radiator) can
reduce cooling capacity. Using a
garden hose, wash the radiator and
the engine to remove any debris
restricting air flow.
CAUTION
Arctic Cat does not recommend
using a pressure washer to clean the
radiator core. The pressure may bend
or flatten the fins causing restricted
air flow, and electrical components
on the radiator could be damaged.
Use only a garden hose with spray
nozzle at normal tap pressure.
3. Mode Button - Shifts the gauge
through three set-up modes: speedom-
eter/tachometer, distance, and time.
NOTE: The Mode Button must be
pressed and released to shift modes.
Approximately two seconds after the
Mode Button is released, the digital
gauge will return to full display.
4. Set/Reset Button - In conjunction
with the Mode Button, sets and resets
various displays on the digital gauge.
Also used to shift from speedometer
function to tachometer function on
the speedometer/tachometer gauge.
Decreasing
31