Hard disk drive checkout
Note: See "System" on page 106 to determine which components a field service technician should replace.
Message
Hard drive x removal detected
(level-critical; hard drive x has been
removed)
Host built-in self test (BIST)
Note: See "System" on page 106 to determine which components a field service technician should replace.
Message
Host fail
(level-informational; built-in self-test for the
host failed)
Bus fault messages
Note: See "System" on page 106 to determine which components a field service technician should replace.
Bus fault messages
Failure reading 12C device.
Check devices on bus 0.
Failure reading 12C device.
Check devices on bus 1.
Failure reading 12C device.
Check devices on bus 2.
Failure reading 12C device.
Check devices on bus 3.
Failure reading I2C device.
Check device on bus 4.
Undetermined problems
Use the information in this section if the diagnostic tests did not identify the failure,
the devices list is incorrect, or the system is inoperative.
102
xSeries 346 Types 8840 and 1880: Hardware Maintenance Manual and Troubleshooting Guide
Action
Information only, take action as appropriate.
Action
1. Reseat the microprocessor.
2. Reseat the VRM.
3. Microprocessor.
Message Action
1. If installed, reseat the I2C cable between Remote Supervisor
Adapter (in PCI slot 5/J5 on the PCI riser card) and the Remote
Supervisor Adapter connector on the PCI riser card.
2. Memory DIMMs.
3. System board.
1. Reseat the I2C cable between the operator information panel
and system board (J22).
2. Operator information panel.
3. System board.
1. Reseat the cable between system board and the power supply
(power cage assembly) (J10).
2. Power cage assembly.
3. Power supply.
4. System board.
1. Reseat the cable between the hard disk drive backplane and
connector (J10) of system board.
2. Hard disk drive backplane.
3. System board.
System board