Setting The Configuration Switches For Speed And Duplex Mode - Allied Telesis at-fs201 Installation Manual

Setting the Configuration Switches for Speed and Duplex Mode

To configure the switch, refer to Table 2 and Table 3 and Figure 8 and Figure 9
and do the following:
1. Power off the switch. Disconnect the power adapter or remove the switch
from the AT-MCR12 rack-mount chassis.
2. Set the DUPLEX MODE for Port 1 to the same duplex mode as the far-end
connection.
12 V D C
12 V D C
PORT
2 1 2 2
1 2 3 4 5
SPEED DUPLEX AUTO
(Mbps) MODE NEG BYTES
10 HALF OFF 1522
100 FULL ON 1518
Figure 8 AT-FS201 and AT-FS202 DIP Switch
PORT
1 2 1 2 1 2
1 2 3 4 5 6 7
SPEED DUPLEX AUTO
(Mbps) MODE NEG BYTES
10 HALF OFF 1522
100 FULL ON 1518
Figure 9 AT-FS203 DIP Switch
AT-FS201, AT-FS202 and AT-FS203 Installation Guide
PORT
2 1 2 2
1 2 3 4
SPEED DUPLEX AUTO
(Mbps) MODE NEG
10 HALF
100 FULL
PORT
1 2 1 2 1 2
1 2 3 4 5
SPEED DUPLEX
(Mbps) MODE
10 HALF
100 FULL
5
BYTES
OFF 1522
ON 1518
6 7
AUTO
NEG BYTES
OFF 1522
ON 1518
11