Table of Contents
Advertisement
Caution: Be aware that your system may radiate heat when used for an extended period of time.
Speakers
Provide stereo sound for your multimedia presentations or listening pleasure.
Air Openings
Caution: Do not block the fan vents while the Mobile Thin Client is in use.
Battery Bays and Battery Release Latches
Refer to "Battery Pack", page 21.
Caution: You computer is shipped with a dummy battery pack. When the second battery is not
installed, you must install the dummy battery pack in the empty bay.
Setting Up Your Mobile Thin Client
1. Before you begin, review "Regulatory Information", page 4 and "Safety Notices", page 7.
2. Remove carefully the contents of the container and keep the carton and the packing materials in
case you need to send the Mobile Thin Client for service.
3. Install the battery(ies). Refer to "Replacing the Battery", page 24.
4. Connect the AC adapter cable to the power port ( C in Figure 5, page 20) of the system.
5. Plug one end of the power cable into the adapter and connect the other end into a wall outlet.
Caution: When using the AC adapter, make sure the power source falls within the system's
compatible range of 100-240 volts AC. Never use the AC adapter if the voltage falls outside of
this range (watch for this when travelling to other countries).
6. LAN (if applicable)
If applicable, connect the LAN cable to the LAN port ( A in Figure 5, page 20).
7. Raise the LCD panel.
8. Briefly press on the power button ( G in Figure 1, page 15) to power on your system.
Removing and Replacing Components
There are no user-replaceable components inside the Mobile Thin Client. If the warranty of your
system offers you this possibility (refer to "NEC UltraCare
support line.
Battery Pack
Note: Although the battery is fully charged at the factory, transit and shelf time may
reduce the initial battery charge. We recommend that the first time you use your system,
you connect it to AC power using the AC adapter. This also recharges your battery(ies).
For more information, refer to "Initial Use or After Prolonged Storage Period", page 22.
Battery Precautions
To prevent accidental battery ignition, rupture, or explosion, adhere to the following precautions.
Warning: There is a danger of explosion if the battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer. Discard used batteries
according to the manufacturer's instructions.
Installing Your Mobile Thin client - 21
SM
Services", page 31), contact the technical
Advertisement
Table of Contents
