NEC Storage S1300 User Manual page 115

Index
1
1-BBU cache enable mode, 1-21
1-CNT cache enable mode, 1-21
A
Access control feature, 1-26
Adding hard disk drives, 3-2
Adding one disk enclosure, 3-7
Adding several disk enclosures, 3-10
Administration software, 1-29
Auto assignment feature, 1-23
Auto repair mode, 1-19
B
Battery backup unit, 1-11
replacing, 4-16
C
Checking the package contents, 2-3
Computer viruses, 4-20
Connecting the disk array unit, 2-12
Controller, 1-9
Creating a logical disk, A-4
Cross call feature, 1-22
D
Data transfer rate
changing, A-6
Disk array unit
disposal, 4-20
Disk enclosures
adding, 3-7
Disposing of the disk array unit, 4-20
Dummy logical disk, 1-18
Dynamic capacity expansion, 1-24
E
Expand LUN, 1-24
F
Fault LED indications, 4-4
Fibre Channel controller
replacing, 4-5
Front panel, 1-3
H
Hard disk drive
adding, 3-2
replacing, 4-17
Hot spare, 1-18
I
Initial assignment feature, 1-23
Installation flow, 2-4
L
LAN card, 1-12
replacing, 4-8
Logical disk
creating, A-4
Logical disk capacity, 1-16
M
Mounting the disk array unit into a rack
cabinet, 2-5
N
NEC Storage AccessControl, 1-29
NEC Storage Manager (iSM), 1-29
NEC Storage PathManager, 1-29
P
Path fail-over feature, 1-24
Power supply unit
replacing, 4-10
Powering off the disk array unit, 2-22
Powering on the disk array unit, 2-21
R
RAID configuration, 1-15
Rear panel, 1-5
Removing a disk enclosure, 3-13
Repair time, 1-19
Replacing
battery backup unit, 4-16
Fibre Channel controller, 4-5
hard disk drive, 4-17
LAN card, 4-8
power supply unit, 4-10
Index 1