Installation Procedure - NEC Storage S1300 User Manual

Installation Procedure

Hard disk drives are hot-swappable. They can be easily installed or removed with the
power of the disk array unit and host system being turned on.
Note:
drive, install or replace them one by one. Do not remove two or more
trays at a time.
Follow the procedure below to install a hard disk drive:
1. Put the location label on the additional hard disk drive.
Before installing the hard disk drive, select the location label corresponding to the
location where the disk drive is to be installed, and put it on the additional hard disk
drive.
Location label
Note:
from left to right in the disk array unit.
If you want to install or replace more than one hard disk
Figure 3-2 Location Label
Additional hard disk drives must be installed sequentially
Upgrading the System 3-3