Masport SUPREME W 210 Owner's Manual page 13

4 / 6 / 7 Pin Electronic Module:
1.
2.
3. Connect the lead wire with the ignition as shown below, no sequence is required, make sure that the wire is securely clipped.
Make sure that the wires are securely positioned on each end and routed through the wire clips.
The BBQ body works as an earth for the electronic module. Make sure that the side table is assembled tightly and forms
the complete circuit. If not, the ignition spark will not occur.
CAUTION: All wires must be properly routed through wire clips.
Verify the ignition system of your BBQ model before connecting the regulator to the gas cylinder
1) Integrated ignition valve - Push in then turn the knob anticlockwise to HI. Test each burner to hear a clicking sound with spark. It
indicates the valve is fitted with integrated ignition.
2) Electronic ignition - Install the battery in the electronic module fitted on the RH side table. Make sure the battery is in good
condition and the battery polarity is correct. Push the button to hear a continuous clicking sound with spark.
Listen & look for the sparks at all the burners' individually and make sure that all the valves are functioning smooth by turning them
"ON" (by pushing the control knob in and turning anticlockwise) and "OFF" (by pushing the control knob in and turning clockwise).
Total 7 pcs of the
lead wire for all
main burners and
rear burner.
The assembled
The assembled
position of the
position of the
electronic ignition
electronic ignition
Connect the lead wire with
Connect the lead wire with
the electronic ignition, no
the electronic module, no
sequence is required,
sequence is required.
13