Masport SUPREME W 210 Owner's Manual page 12

15. Connecting the ignition wire/ wires to the electronic module
Note:
1) The rear burner valves operate with the electronic ignition.
2) All the side burner valves operate with the integrated ignition.
Check the diagram of module to determine the BBQ ignition type
1) If the module has only one pin i.e. connecting single wire then Rear burner operates with electronic ignition
2) If the module has multiple pins for connecting the wires then Rear burner and Main burners operate with electronic
ignition.
Single Pin Electronic module
Follow the diagram to connect the wires between the electronic module and the electrode.
Connect the lead wire with the electronic ignition as shown below. Make sure that the wire is clipped tight.
Single Pin Electronic Module:
12
4 Pin Electronic module
Ignition module attached on
the Right side Table
6 Pin Electronic module
Connect the lead wire with
the electronic ignition, no
Connect the lead wire with
sequence is required,
the electronic ignition, no
sequence is required,
7 Pin Electronic module