Table of Contents
Advertisement
Installation
If you are installing the switch on a desk, make sure it is placed on a
level, secure desktop.
Do not place objects on top of the switch.
Do not expose the switch to moisture or water.
Make sure it is in a dust-free environment.
Use dedicated power circuits or power conditioners to supply reliable
electrical power to the network devices.
Note
To install the switch vertically on a wall, use the AT-BRKT18 Wall-
Mount Bracket; order it from your Allied Telesyn representative.
Installing the Switch on a Desktop
1.
Locate a level, secure surface for the switch.
2.
Apply the four rubber feet to the bottom of the unit.
3.
Put the switch onto the rubber feet on the desktop.
Warning
The power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord. ! 8
4.
Apply power to the switch by plugging the power cord into the rear of
the unit and plugging the other end into a wall outlet. Verify that the
Power LED lights green.
If the Power LED does not light green, refer to Chapter 3, for further
information.
5.
Connect the data cables and observe normal operation as indicated by
the port LEDs. Refer to Table 1 on page 3 for LED information. For
Port 4, set the MDI Button to the correct setting. Refer to Table 2 on
page 4 for the MDI setting.
8
Advertisement
Table of Contents
